. .

NEW: Product Finder

- Quick and User-Friendly product search
- Direct order through Bilz Product Finder

The Bilz product finder is optimized for Internet Explorer



Fairs 2017

Date/place of current fairs
more »


BPMS- Pneumatic Measurement System of Balance for Process Measurement



Bilz measurement system

SYSTEM STRUCTURE FOR PROCESS MEASUREMENT
A fine machining process like honing is usually one of the last processing steps in the fabrication of forms, which includes certain tribology and dimensional precision properties. A precise control of the process is necessary. The measurement system from Bilz enables the integration of the honing process in machining centres. Honing tools with pneumatic measurement nozzles are required.
The recorded measured value, usually the diameter, is the criteria that is permanently compared to the requested size. When the measurement value is achieved, the interface communicates the value to the NC-Control which then stops the honing process. Because of this, there is no operator needed to monitor the actual hole size. The communication is made in 4 bit resolution over the PLC and up to 16 commands can be exchanged. ...further information...